Engine (20)

High quality 3" blower hose. As there can be cross-over among the same models/years on sizes that were used, please measure the diameter of your blower to ensure you order...

High quality 4" blower hose. As there can be cross-over among the same models/years on sizes that were used, please measure the diameter of your blower to ensure you order...

CRANK DRIVEN RAW WATER PUMP USED ON ALL ENGINES EXCEPT LT1 AND LTR FOR THOSE ENGINES USE 685020-4 (Impeller & gasket used for either of these pumps: Part #685007 &...

Engine Plug for Malibu Monsoon M series engines

Water strainer to filter debris that could damage the impeller or lodge in the cooling system. Some boats had these installed at the factory but most can add them as...

Gasket, Strainer, ClearBbowl, 20 mesh, 1-1/4NPT, Flush Port

OIL PRESSURE SWITCH USED FOR LOW-PRESSURE ALARM

NARROW BAND 02 SENSOR USED ON CHEVROLET AND FORD ENGINES USEDPOST CAT IN FORD APPLICATION (4 WIRE)

 1/8 PIPE THREAD OIL PRESSURE SENDING UNIT

Surf Pipe coupler to use with surf pipe installation for power wedge II.

Hose, Exhaust, 4 Softwall, 28 Long, Rev 1, 18-20 NOTE: Exhaust hose needed to install surf pipe

Alternator for M series Malibu Monsoon Engines.

FORD 6.2 RAPTOR OIL PRESSURE SENSOR

95 AMP ALTERNATOR USED ON 6.2 FORD ENGINES

CHEVROLET SMALL BLOCK EXHAUST MANIFOLD GASKET

Muffler, V-Drive, Catalyst, Barbed Inlet/Outlet, 12-15. Please call in with HIN to verify fit before ordering.

Malibu M Series raw water pump. replaces the old gen Sherwood system with the johnson F6B-9. Used on all Malibu/Axis with M Series engine 2020-Current.Replacement Impeller: E100037