Hardware (110)

Latch kit to lock walk through door. The included screws are not long enough to directly screw into the frame -- recommend using rivets instead for a better hold. Sold...

Pull-pin assembly with wear button (small white plastic insert in the tip). The threaded end of this pin is what the pull knob screws onto, which when pulled unlocks the...

Thumb pins to assist in lowering the manual wedge (to slide the pins in to and ulock the wedge from the "up" position). Sold individually.Does not come in a kit...

Tension spring for the Malibu and Axis spinning board racks. This is the spring that keeps the knob locked down.

Manual wedge release slide pin for stainless steel floating wedge only!!.- Sold individually.Does not come in a kit -- thumb pins and spring are sold separately.

Flush lock for many engine hatches between 99-16. Comes with all required hardware to install.

Thumb pin spring that keeps the slide pins out to lock the manual wedge in the "up" position.Does not come in a kit -- the slide pins and thumb pins...

Single wing style latch to secure the engine compartment side panels. Does not include hardware.

Replacement pull-pin knob for all G3 spinning racks. This is the gray anodized color.

Bushing that houses the pull-pin assembly on G3 spinning/bungee board racks.

Glove box lock kit.

Standard 3/4" t-handle drain plug for use in the bilge drain holes in the bottom of the boat. This will work with the drain hole near the v-drive/transmission and the...

For use with most 1-1/8" prop shafts. Includes a brass key, nylock nut, and stainless cotter pin.

Universal Airmar paddlewheel repair kit. Includes the paddlewheel, bar, and a variety of o-rings. Not all o-rings will be used but are included for different models. Just match the new...

Standard 1/2" brass drain plug you pull in the transom of your boat to drain excess water that has accumulated in your boat.

For use with most 1-1/8" prop shafts. Includes a stainless key, nylock nut, and stainless cotter pin.

Fitting/drain in bottom of ice chest to and which attaches to the drain hose that runs to the back of the boat.    

Bracket that secures the Surf Gates actuators to both the hull of the boat and the Surf Gate paddle.